2. Lead Wire Color Label
2-1. External Day/Night Control (Option)
Select Day/Night mode using external equipment, by connecting control lines to the appropriate
terminals.
DAY&NIGHT EXTERNAL INPUT
Switches the cameras D/N mode to either Day or Night based on the input status. Refer to the
diagram below. The
camera’s CNTL SIGNAL of D/N AUTO mode must be set to EXT2 for this
to function.
●
Open contact: DAY
●
Close contact: NIGHT
2-2. Alarm Out - Open Collector 5V/10mA)
Motion detection signals are output through this port. Active state is Low (GND).
Normal: Open Collector, ALARM: Low (GND)
2-3. Power Input Terminal
RED & WHITE: These terminals accept 24 VAC or 12 VDC. When using 12 VDC it is
recommended to use a DC power supply that can support an inrush current of 0.55A.
2-4. Camera Control
BROWN: RS 485+
BLUE: RS 485-
3. Video:
BNC connector used to connect the camera to a monitor, switcher, etc.
Camera Connection 14
24VAC/12VDC
24VAC/12VDC
RS 485(+)
RS 485 (-)
BLACK
GND
GRAY
DN EXT-IN
1. Lens:
Allows a wide area to be monitored.
Black
GND
Gray
DAY&NIGHT INPUT
