6. Fasten the base to the wall or ceiling with the appropriate hardware for the mounting surface, lag bolts
and sleeve for cement surfaces or machine screws for other surfaces.M6x35 tapping screws are supplied
for use, if suitable. A rubber washer is provided for each mounting hole for environmental sealing. If the
rear cable access is used, be sure that holes are aligned correctly so the cable is routed to allow a flush
installation of the base. As a mounting alternative, align the mounting holes with a 4 x 4 electrical box and
fasten the base to the box with machine screws.
Installation 12
Note:
To assure a watertight seal, apply silicone sealant around the area where the base meets the wall or
ceiling. Vicon recommends Dow Corning® 737 neutral cure sealant or equivalent.
Seal around the
housing base tightly
using the silicone.
