Vicon ROUGHNECK V910, Installation & Operation Manual

Page: 13 / 25

Figure 5
Cable Preparation
Camera Power Connections
Note: Vicon systems and com clean, stable power source. ponents, like most electronic equipment, require a
Voltage irregularities such as surges, drops, and interruptions can affect the operation of your
equipment and, in severe cases, damage certain components. Vicon strongly recommends the use of
line conditioners, voltage regulators, and uninterruptible power supply (UPS) systems.
ower is connected through a two-position push terminal connector on the PC board (TB1). Refer to Table 2
terminal on the PC board.
er cables. Then strip off approximately 0.25 in.
3.
he camera is shipped prepared for 24 VAC.
Table 2
Camera P nections
Pin N
P
for the input power connections.
1. Locate the power cable push
2. Strip approximately 1 in. (25 mm) of insulation off pow
(6 mm) of insulation off each individual wire. Refer to Figure 5. Push the plunger down and insert the wire
into the connector body. Repeat for each connection. Refer to Table 2.
Press the cable connector onto the board screw terminal.
T
ower Con
umber Function
1 24 VAC
2 24 VAC Return
Note: A grounding tab is provided on the PC board for those installations requiring a ground. The use of the
ground tab to earth ground is necessary to provide protection to the camera. A Faston (lug) is provided
in the accessory kit.
Power Supplies
Vicon recommends several power supp s of the installation. Refer to the table
Model Number Product Code Description
lies, depending on the need
below. For other multichannel power supplies, contact Altronix Corporation at 888-258-7669.
S24PS 7027
7668
V2416-8PS 7669 16-channel indoor, 24 VAC; 0.5 A/channel
Single channel outdoor, 24 VAC
V248-3.5PS 8-channel indoor, 24 VAC; 0.4 A/channel
Heater Connections
The outdoor V910 has a heater in the base. Refer to Figure 1. The unit is delivered with the heater
connection made to the connector (P4) on the PC board. Refer to Figure 4.
XX137-00-03 Rev 504 Roughneck V910 Dome Cameras Installation
•
7