3. There are two (2) cable access holes provided. Drill a hole in the wall or ceiling and route video and
power cables to the selected location and through one of the cable access holes. A 1/2-inch connection
(customer-supplied connector) is provided on the side of the base; the rear port is sized to accept a 1/2-
in. (customer-provided) connector. A conduit or electrical connector (screw-type) can be used in this
threaded hole. See Figures 1 and 2 for hole locations.
4.
If it is desirable to use the rear cable access hole, remove the black hole plug it is shipped with and route
the conduit through the hole. Remove the plug from the side cable access hole and insert the vent plug
provided. If the side cable access hole is used, remove the plug it is shipped with and insert a Street Tee
(customer provided) into the cable access hole. Route the conduit through the top hole and insert the
vent plug provided into the bottom hole. Refer to Figure 3 for installation options.
Note:
For
outdoor installations,
Vicon recommends that the vent plug should only be used if fogging
conditions exist. Additionally, if the side cable access hole is used, the base must be mounted so the
hole is pointed directly downward.
Figure 3
Installation Options
5. Fasten the base to the wall or ceiling with the appropriate hardware for the mounting surface, lag bolts
and sleeve for cement surfaces or machine screws for other surfaces. A nylon washer is provided at each
mounting hole for environmental sealing. If the rear cable access is used, be sure that holes are aligned
correctly so the cable is routed to allow a flush installation of the base. As a mounting alternative, align
the mounting holes with a 4 x 4 electrical box and fasten the base to the box with machine screws.
6. Rotate camera/lens assembly to the desired position. Make sure that the camera/lens assembly is
oriented correctly, so that the markings on the camera/lens assembly are at the top. Make sure that the
pan bracket is on the left side of the camera when looking into the lens.
Do not move the camera/lens
assembly by holding onto the lens.
For roll adjustment: simply rotate unit to desired position. If a unit
with a varifocal lens is being installed, the lens can be manually adjusted for iris, focus and angle of view
(telephoto/wide). On autoiris models, there is a potentiometer for adjustment. When making adjustments,
be sure that the lens does not hit the dome.
Note:
To assure a watertight seal, apply silicone sealant around the area where the base meets the wall or
ceiling.
XX137-00-03 Rev 504 Roughneck V910 Dome Cameras
Installation
•
5
Summary of Contents for ROUGHNECK V910
Page 2: ......
