Outdoor Dome Series | Quick Guide
12
2.2.5 Mounting the Camera
⚫
Use the mounting template to prepare a mounting area for surface mounting.
1.
Place the supplied mounting template on a mounting surface. Drill 6 mm (0.2”) outer holes at the T1
(double gang box) or T2 (single gang box) template positions on the mounting surface. Then insert 2
or 4 supplied plastic anchors into the holes.
2.
If feeding wiring from the hole on the rear of the camera bottom case, create a circular opening
corresponding to the “Bottom conduit hole” on the mounting template on the mounting surface.
3.
If feeding wiring from the side of the camera bottom case, it is not necessary to drill a hole on the
mounting surface. The “Side conduit hole” indication on the mounting template is for user to identify
while mounting.
NOTE
: Properly close the unused hole with the supplied conduit hole plug. For example, block the
side conduit hole with the plug when using the bottom conduit hole for cable entry and vice versa.
Figure 2 - 6: Mounting Template for Surface Mount
Summary of Contents for Roughneck Pro V2000D Series
Page 26: ...8...
