28
Preparing for operation
Adjusting the
working depth
Distance of tine to ground is adjusted in the work position via the
crank.
> Use the tractor's hydraulic control device to bring the implement
into the work position.
> Drive forward approximately 2 meters until the running wheels are
correctly aligned.
> Release the crank locking device.
> Adjust the working depth using the crank.
> Secure the crank with the crank locking device to ensure it does not
twist.
N
OTE
The tines should lightly touch the ground.
Adjust tedder
inclination
The tedder inclination determines how far the harvest is ejected from
the rear. Using the eccentric screw on the wheel, allow the running
wheel axles to move by 3° (infinitely variable).
N
OTE
All wheels must be set the same. Flat tedder inclination results in op-
timised harvest pickup.
Adjust tedder inclination in the work position as follows:
> Use a screwdriver (SW 30) to turn the eccentric screws to set the
required tedder inclination identically for all running wheels.
> Check the working depth and adjust if necessary.
Crank locking device
Crank
0°
3°
Eccentric screw
