Installation
13
6
How to Replace Batteries
This section applies to the scale of the dry-cell battery type. Return to the previous section when you
use a power supply box type. Be sure to replace batteries in a non-hazardous area.
Loosen the screw in the rear of the display
and the battery box can be removed.
Remove the relay connector in the battery
box.
Do not pull the cable since it may cause wire
breakage. Hold and pull the connectors when
you disconnect the cables.
Remove the battery box cover with the small
wrench in the accessory kit.
Replace the batteries in the correct direction.
Install the cover with the small wrench.
Connect the relay connector of the battery
box and install it on the display.
Important
The type of the cell batteries is limited to C-size red manganese batteries (type R14P(NR) National
/ Panasonic). Use of other batteries is strictly prohibited because they may not be of the required
explosion-proof performance.
Remove the battery box.
Battery box
Scale cable
Display
Relay connector
Phillips
screwdriver
Small wrench
Insert batteries.
Battery box
Dry-cell battery
Attach the battery box.
1
2
3
