1. Low Level Output
A daisy chain output For connection to another amplifier with a low level input using only a single RCA output from the source
(headunit).
2. Low Level Input
For connection to any source (head unit) with a low level output. This is your RCA output from the source (headunit)
3. Gain Control
Used to match the input signal of the source to the amplifier. See the setup section for more details.
4. Bass Boost Switch
To provide up to an extra +24 dB of bass boost at 45 Hz. Use this boost to Increase bass output from the amplifier.
5. Low pass Crossover Control
The control is used to select the low pass filter frequency. The frequency ranges are from 30 Hz to 300 Hz.
6. crossover control switch
This switch is used to select high pass, low pass or flat (no crossover) operation for the amplifier speaker outputs.
7. High pass Crossover Control
The control is used to select the High pass filter frequency. The frequency ranges are from 50 Hz to 1KHz.
8. Gain Remote Input Jack
Use to plug in the remote bass controller. (optional ) see back
9. High Level Input
To be used when no RCA's are available. Use the provided loom to connect to closest speakers. The loom connector will only
fit one way around. Once plugged in you should connect the wires as below:
Left Positive - Brown Right Positive - Black Left Negative - Blue Right Negative - Green
8. Rear Gain Remote Input Jack
Use to plug in the remote bass controller.
10. Gain Remote Controller
This remote can be mounted in the front of the car and will give you the ability to raise the gain of the amplifier remotely in
the range of 0.25 volts to 6 volts. (Optional accesory, see back for details)
11. Indicator LED
When the amplifier is operating correctly the LED will show as blue. When the amplifier is in protection mode the LED will
show as red.
12. Power Connections
Power connections. See Connections section for details on correct connections.
13. Fuses
Please ensure the following fuse rating is used when replacing fuses: 15 amp x 2
14. Speaker Terminal Output
For connection to the speakers. See Application section for wiring examples.
