Chapter 1
Getting started
Attaching modules
ONA-800 Getting Started Guide
Page 6
22142812, D1 R004
August 2020
Attaching modules
This section describes how to attach CAA/OTDR modules and solution modules to the
ONA-800.
CAA/OTDR Modules
The following procedure describes how to attach CAA/OTDR modules to the ONA-800.
To attach CAA/OTDR modules
1
Power down the ONA-800 and disconnect from AC power.
2
Place the unit so that you have access to the back and remove the termination
cover by removing the screws that hold it in place.
3
Locate the hinges on the module and insert them into the base at a 45 to 60
degree angle.
4
Pivot the module down towards the connector.
5
Seat the module into the connector with slight pressure.
6
Tighten the screws on the module.
The following procedure describes how to remove CAA/OTDR modules.
To remove CAA/OTDR modules
1
Power down the ONA-800 and disconnect from AC power.
2
Place the unit so that you have access to the back.
3
Remove the screws on the module.
4
Remove the module from the ONA-800.
Solution modules
The following procedure describes how to install a solution module to the ONA-800.
To attach a solution module
1
Power down the ONA-800 and disconnect from AC power.
2
Place the unit so that you have access to the back and remove the termination
cover by removing the screws that hold it in place.
3
Set the module onto the base, ensuring the mating connectors between the two
