13
3.2.4 Cable Connection
The device reserves two cable exits. The pin diameter shall be less than 15mm. One of the
cable exits has M22 screw thread and can work with the default combination cable to remove
the risk of the dragging and pulling of the cable.
The device has two waterproof airproof plugs (One default position is the cable exit of the
chassis of the device and the other is in the accessories bag.). The waterproof airproof plug
has two functions. One is to fill in the cable exit and pull through the cable. It supports the
cable whose diameter ranges from 4.0~6.0. It is very convenient for you to do the waterproof
work when you pull the cable through your own exit. Please refer to the steps listed.
Step 1
Take the waterproof airproof plug out, pull the cable (diameter ranges from 4.0 to 6.0) through
the waterproof airproof plug. See Figure 3-11.
Figure 3-11
Step 2
Before you go to the Step 4 in the chapter 3.2.1 installation steps, please pull through cable
with the waterproof airproof plug to the device chassis via the installation hole at the bottom of
the chassis and then connect the cable pins.
Step 3
Refer to Step 4 and Step 5 in the chapter 3.2.1 installation steps to install and connect the
cable pin to the device and then follow the proper steps to go on the installation.
Important
This series product has the power connection pin and I/O connection pin for you to pull
through the signal cable.
