100C Air Compressor Kit
MOUNTING AND WIRING
1. Disconnect ground cable from vehicle’s battery.
2. Temporarily position the air compressor in the location where it will be mounted.
3. Route ground wire to the negative post of the battery or to an appropriate grounding point
and cut ground wire to length as needed.
4. Mount air compressor with the four sets of bolts, nuts, washers, and locking washers provided.
(See Fig. 2 for Mounting Instructions)
5. Refer to Remote Air Filter Installation Instructions included in the Remote Inlet Air Filter Pack.
6. This air compressor may be equipped with a heat resistant leader hose (Not applicable to P/Ns
10014 / 10016 / 10019). This leader hose is designed to prolong the life of your air line. Do not
remove this leader hose from air compressor.
7. Please note, the leader hose that came with your compressor may have a built-in inline check
valve installed. Do not remove inline check valve from leader hose if so equipped.
8. If equipped, select a proper location to mount leader hose with hose bracket provided. Avoid
locations where leader hose may become tangled with wires and other hoses.
9. To mount hose bracket, drill hole with 3/16” drill bit and push self–anchoring hose bracket pin
into hole. Route leader hose through hose bracket and secure hose by pressing bracket clamp
into locked position.
10. To remove hose from the hose bracket, simply press down on the hose clamp release tab to
release bracket clamp. (Fig. 3)
11. Connect compressor positive lead wire to one of the leads of your pressure switch.
12. Make sure that your compressor setup is properly fused. For appropriate fuse size, refer to amp
draw of compressor in the Specifications section of this manual.
13. Always locate fuse as close as possible to power source.
14. Before connecting to power source, re-check to make sure that all connections
are properly connected.
15. Connect and test compressor system by running the compressor for a short time to build up
pressure in your air tank.
16. Once air pressure reaches preset cut out pressure of your pressure switch, the compressor
will shut off. Inspect all air line connections for leaks with soap and water solution. If a leak
is detected, the air line may not be cut squarely or pushed all the way in. Tighten connections
if needed.
(Fig. 1) Air Compressor Kit Installation Parts List:
100C - P/N 10010, & 10014
100C - P/N 10016, & 10019
A. Hose Bracket (1pc) (P/N 10010 only)
A. Mounting Bolts (4pcs)
B. Mounting Bolts (4pcs)
B. Flat Washers (8pcs)
C. Flat Washers (8pcs)
C. Locking Washers (4pcs)
D. Locking Washers (4pcs)
D. Nuts (4pcs)
E. Nuts (4pcs)
E. Vibration Isolator (4pcs)
F. 1/4” NPT F x 1/4” Barbed Fitting (1pc)
G.1/4” Air Line (1pc)
H. Air Line Clips (3pc)
I. Screws (3pc)
J. Air Filter Element (2pcs)
K. Remote Inlet Air Filter with Filter Element (1pc)
USER MANUAL
REDUCER
A
B
C D E
A
B C D
F
H
I
K
G
J
E
