38
for the purpose of its investigation (all that is necessary to be asked for because the appliance must be
inspected by an expert who analyses the reasons of the fault). The water heater during the transport
must be marked in a legible and visible way (best together with the address and signature of the end
user) in order to avoid its incorrect identification. The adequate photo documentation is required too and
it will show the scope of damage, installation (cold water piping, hot water drain, heating system inlet and
outlet, safety parts, expansion tank – if it occurs) and also the damage localization on the water heater.
The manufacturer also reserves the right to ask the purchaser to submit all documents and matters
necessary for the purpose of explanation. The service will perform its duties by virtue of product liability
only on condition that the documentation submitted by the party lodging the claim has proved that the
damage was caused by the manufacturer’s product. By the time of the case full clarification and reasons
determination the manufacturer is considered not to be bearing the blame for it. The service and
installation manual non-observance is considered to be the negligence and results in annulment of
liability as for the compensation for arisen damage. Illustrations and data are not binding and can be
changed without notice at the moment of technical improvements implementation.
The manufacturer reserves the right to possible misprints and technical changes.
Information for customer
Packaging edentification
PE Plastic sacks, folie, corrugaled board, iron and plastic fix
line
Assessment reference
Identification od principál materials used. Paper, Polyethylene, iron, wood
Part 1: Summary of assessment
Standard/Report
Assessment requirement
Claim
Note
1.1 Prevention by source
reduction
YES
1.2 Heavy metals and
ensure below maximum permitted
levels for components
(CR 13695-1:2000)
YES
1.3 Other
noxious/hazardous
substances
ensure in compliance with
(CR 13695-2:2002, EN 13428:2000)
YES
2
Reuse
ensure reusability in all terms of the
standard for the functional packaging
unit (EN 13429:2000)
NO
3.1 Recovery by material
recycling
ensure recyclability in all term sof the
standard for the functional packaging
unit (EN 13430:2000)
YES
3.2 Recovery in the form
of energy
ensure that calorific gain is achievable
for the functional packaging unit
(EN 13431:2000)
YES
Iron - NO
3.3 Recovery by
composting
ensure compost ability in all terms of
the standard for the functional
packaging unit (EN 13432:2000)
NO
NOTE Conformity with EN 13427 requires affirmative responses to sections 1.1; 1.2; 1.3 and to at
least one of 3.1; 3.2; 3.3. In addition, where a claim of reuse is made section 2 should also
record affirmative responses.
Part 2: Statement of conformity
In the light of the assessment results recorded in part I above, this packaging is claimed to comply
with the requirements of EN 13427:2000.
Summary of Contents for 200 I
Page 1: ......
