VIA Technologies NAB-7400, User Manual

Page: 56 / 76

Chapter 3
48
IRQ
S
A
CTIVITIES
: Move
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
Menu Level
If you choose Disabled, the
power management unit will
not monitor any IRQ activities.
Item Help
Primary INTR [ON]
IRQ3 (COM 2) [Enabled]
IRQ4 (COM 1) [Enabled]
IRQ5 (COM 3) [Enabled]
IRQ6 (Floppy Disk) [Disabled]
IRQ7 (Reserved) [Disabled]
IRQs Activities
Phoenix - AwardBIOS CMOS Setup Utility
IRQ8 (RTC Alarm) [Disabled]
IRQ9 (IRQ2 Redir) [Disabled]
IRQ10 (COM 4) [Enabled]
IRQ11 (Reserved) [Disabled]
IRQ12 (PS/2 Mouse) [Enabled]
IRQ13 (Coprocessor) [Enabled]
IRQ14 (Hard Disk) [Enabled]
IRQ15 (Reserved) [Disabled]
Primary INTR
Restores the system to an active state if IRQ activity is detected from any of
the enabled channels
Settings: [Off, On]
IRQ3~IRQ15
Enables or disables the monitoring of the specified IRQ line. These fields are
only available if “Primary INTR” is on.
Settings: [Enabled, Disabled]
Note: IRQ (Interrupt Request) lines are system resources allocated to
I/O devices. When an I/O device needs to gain attention of the
operating system, it signals this by causing an IRQ to occur. After
receiving the signal, when the operating system is ready, the system
will interrupt itself and perform the service required by the IO device.