VIA Technologies EPIA-NL, User Manual

Page: 62 / 79

Chapter 3
54
Bank Interleave
This item is for setting the interleave mode of the SDRAM interface.
Interleaving allows banks of SDRAM to alternate their refresh and access
cycles. One bank will undergo its refresh cycle while another is being
accessed. This improves performance of the SDRAM by masking the refresh
time of each bank. This field is only available when “DRAM Timing” is set to
“Manual”.
Settings: [Disabled, 2 Bank, 4 Bank]
Precharge to Active (Trp)
This field is for setting the length of time it takes to precharge a row in the
memory module before the row becomes active. Longer values are safer but
may not offer the best performance. This field is only available when “DRAM
Timing” is set to “Manual”.
Settings: [2T, 3T, 4T, 5T]
Active to Precharge (Tras)
This field is for setting the length of time it a row stays active before
precharging. Longer values are safer but may not offer the best performance.
This field is only available when “DRAM Timing” is set to “Manual”.
Settings: [6T, 7T, 8T, 9T]
Active to CMD (Trcd)
This field is only available when “DRAM Timing” is set to “Manual”.
Settings: [2T, 3T, 4T, 5T]
REF to ACT / REF to REF (Trfc)
This field is only available when “DRAM Timing” is set to “Manual”.
Settings: [12T, 13T, 14T, 15T]
ACT(0) to ACT(1) (TRRD)
This field is only available when “DRAM Timing” is set to “Manual”.
Settings: [2T, 3T]