EN
4
| BLUE LAGOON SPA INOX UV-C 12 & 15 WATT
OPERATION
The special Philips UV-C lamp in the Blue Lagoon Spa Inox UV-C generates UV-C radiation with
a wavelength of 253.7 nm, and this ensures the destruction of bacteria, moulds and viruses. This
lamp has been specially designed by Philips, and is ideal for water temperatures up to 40 degrees
Celsius. The Blue Lagoon Spa Inox UV-C ensures fresh, clean and clear water in an efficient and
environmentally-friendly manner. The water is guided through the UV-C device by means of a
pump. The UV-C radiation neutralises bacteria, viruses and other primitive organisms and prevents
their reproduction. The Blue Lagoon Spa Inox UV-C has an integrated electronic ballast. This ballast
ensures maximum lamp performances. In addition, the stainless steel housing provides additional
reflection of the UV-C radiation, thereby increasing the efficiency up to 35%. Thanks to the Blue
Lagoon Spa Inox UV-C, your water will be disinfected efficiently and safely, and the quality of your
water will remain excellent.
INSTALLATION OF THE UV-C DEVICE (DRAWING 1)
The ideal place for the installation of the device is immediately behind the filter. Never submerge
this device in water. Always install the device outside of the pool. Ensure that there is always water
flowing through the unit if the lamp is on.
1. Determine where the device will be installed. (See Drawing 3).
2. Fit the unit into the circuit using suitable couplings.
3. Connect the end of the cable (D) to the top of the lamp (A).
4. Activate the pump and check the flow and any leakage of the system.
5. Insert the plug of the UV-C device into a wall socket with a safety ground and fitted with an residual
current circuit-breaker (max 30 mA). Check the operation of the lamp through the transparent
looking glass. You can switch off the device by pulling the mains plug out of the socket.
6. We recommend you to provide the unit on the housing (C) with a separate grounding, although
the lamp is provided with its own grounding (in case it is provided in the power supply).
DISMANTLING/MAINTENANCE
Always switch off the power supply while maintaining/dismantling the device.
The device must be cleaned minimal twice a year. If there is an increase in pollution, the quartz glass
tube (B) must be cleaned. The special lamp (A) must be replaced after 5,000 operating hours (± 1x a
year) at the latest. The stainless steel housing can be cleaned with a soft brush.
1. Unscrew the inlet and return and drain the water from the device.
2. If connected, pull out the earth wire of the housing.
3. Unscrew the nut (E), remove the lamp from the quartz glass and, if necessary, replace the special
lamp (A). As these parts are very fragile, caution is essential.
4. Carefully remove the quartz glass (B) using a large, flat screwdriver (see Drawing 2). Never use force!
5. Clean the quartz glass with a suitable agent. Always use a soft cloth to clean the glass and
prevent scratches.
Please read carefully through these instructions
for use before installing this device.
BLUE LAGOON SPA INOX UV-C 12 & 15 WAT T
Summary of Contents for Blue lagoon UV-C 12W
Page 1: ...UV C and Pool equipment SPA INOX UV C 12 15 WATT MEMBER OF...
Page 2: ...1 2 BLUE LAGOON SPA INOX UV C 12 15 WATT BLUE LAGOON SPA INOX UV C 12 15 WATT D E A B G C...
Page 3: ...2 3 BLUE LAGOON SPA INOX UV C 12 15 WATT 3 UV C and Pool equipment...
Page 19: ...BLUE LAGOON SPA INOX UV C 12 15 WATT 19 UV C and Pool equipment...
