Quick Start Guide of PRO-NVR-Smart
10
Basic Hardware Connection
Before you can access the station via network, you need to properly power on the station
and connect it to network.
Network Connection
Note:
Consult your network administrator before installing the station to avoid possible
network conflicts.
Use the network port on the rear panel and a network cable with RJ-45 connectors to
connect the station to your network.
Output Connection
Connect a VGA cable or HDMI
TM
cable to the video out interface (VGA or HDMI
TM
) on the
station.
Connect the VGA cable or HDMI
TM
cable to the display unit.
Hard Disk Installation
Before you start:
Disconnect the power from the NVR before installing a hard disk drive (HDD). A factory
recommended HDD should be used for this installation.
Tools Required:
Screwdriver.
Steps:
1. Remove the cover from the NVR by unfastening the screws on the back and side.
2. Install the HDD using the provided screws and fasten the screws on the bottom to fix
the HDD.
3. Connect the HDD to the motherboard of the NVR with the included data cable.
4. Connect the power cord to the HDD.
Summary of Contents for PRO-NVR-Smart
Page 1: ...Quick Start Guide...
