3
The section area of power code copper core(a) MUST BE:
18L machine,20L machine: a≥2.5
㎡
36L machine,48L machine:a≥4
㎡
4
Under-size power code can result in low voltage and overload,which affect
machine performance or causing damage.
3) Installation
1
Open the carton bag,you will find a parts bag in the hopper.In the parts bag you
will find consumable parts,keep the spare parts for the future replacement.
①
Horn-shaped rubber rings
②
Caps
③
O-rings
④
H-rings
2
Please check the nameplate on the right panel,confirm this is the correct
model(voltage,frequency and power)you order.
3
Install the discharger properly,tighten it to the
machine with 4 bolts(2 long ones up,2 short ones
down),screw the 2 bolts in diagonal at the same
time,mate sure no gap between the discharger and
the machine,otherwise,water or mixture can leak
from it during washing or making ice
cream.Notice:sensor plate MUST BE on top of all
valve stems.(see right photo)
④
Install the handles to the valve stems one by one ,in the mean time,slowly push
the steel pin through the discharger and the handles.(Refer to below photo for the
correct direction of the handles)
5.How to Make ice cream
1) Wash
Connect it to 16A socket,switch on the power
with the stick on the left down part of control
panel.Pour water from the hoppers to fulfill
the cylinders,press“CLEAN”mode.Repeat this
2-3 times,until the water comes out is all
clean.
2) Make mixture
Currently in the market,there are ready-made mixture of ice cream,or the powder
that needs to mix with water.Please follow the instructions and formula on powder
package(generally speaking:1kg powder to 2.5-3kg water),stir them even,let them
completely dissolve and mix together,avoid lumps forming,leave it still for 30
minutes.These are very important factors for the texture and amount of the ice
cream later produced.
Summary of Contents for ZM-A168
Page 1: ...ICE CREAM MACHINE MANUAL...
