110132.02
9
Electric marine toilet SMTO2S - WCPS
ENGLISH
8 Fault Tracing
Ensure that the power supply is switched off during repairs.
Fault
Possible cause
Solution
The motor runs but the water in the toilet
bowl is pumped out too slowly or not at
all.
The outlet pipe is blocked.
Descale the outlet pipe.
The discharge height is too great.
Modify the installation.
The motor makes a rattling noise.
Hard object hitting the revolving blades
Remove object.
The cycle is not carried out when the
switch is pressed.
There is no power
Check the main switch and fuse
There is no connection between the
switch and the toilet.
Repair the connection.
The switch is faulty.
Replace the switch.
The cycle starts but water flows too slowly
into the bowl.
The magnetic valve filter is blocked.
Clean the filter.
Water pressure too low.
Ensure minimum water pressure is 1.5
bar (24 psi).
Cycle starts but no water flows into the
bowl.
The water supply stopcock is turned off.
Open the stopcock.
Faulty magnetic valve.
Replace magnetic valve.
Water pressure too low.
Ensure a minimum water pressure of 1.5
bar (24 psi).
6 Maintenance
Traditional toilet cleaners can be used to clean the toilet and to
remove scale.
In order to prevent scale deposits from building up in the pump
these must be removed regularly as follows:
• Shut off the water supply by closing the ball valve.
• Pump the toilet empty. (
PUMP OUT
')
• Pour about 1 litre of vinegar or scale remover into the toilet
pot and let it soak for some hours.
• Open the ball valve again and carry out several cycles in
order to flush the toilet pot thoroughly and remove all the
water used from the pump.
How often the scale needs to be removed depends on the hard-
ness of the water, but it should be done at least twice a year.
Do not use products based on sodium (unblocking products)
or solvents.
If seawater is used for flushing the toilet should be rinsed
through with fresh water every so often to prevent salt deposits
from building up.
7 Technical details
Voltage
:
12 V
24 V
Current
:
25 A
15 A
Maximum vertical lift
in outlet
:
3 metres
Maximum hose length
:
30 metres
Pump capacity at discharge
height of 3 metres
:
36 litres/min @ 12 V
43 litres/min @ 24 V
Maximum water
temperature
:
35˚C
Noise level
:
61 dBA
Protection
:
IP44
Weight
:
18 kg
