![background image](http://html1.mh-extra.com/html/vetus/iltconw/iltconw_installation-instructions-and-owners-manual_1010439019.webp)
110141.01
19
vetus®
Connection kit for waste water tanks
6 2 Fitting the connection cover
Clean the inside of the tank before fitting the
connection cover
• Connection cover (2)
Position the connection cover (2) as shown
in the drawing and fit the nut (3).
• Connections
Installed are the inlet connection (4), hose
pillar 38 mm, and the vent connection (5),
hose pillar 19 mm diameter.
The 38 mm hose pillar can be replaced by a
25 mm hose pillar or a blind plug.
Replace the blind plug (7) with a 19 mm
hose pillar if an (extra) inlet connection is
required.
Extraction connection
Replace the blind plug (6) with a hose pil
lar, 38 mm diameter, if an extraction pipe is
installed
• Sender for fuel level gauge
If desired, remove the cover (8) and install a
sender for the tank level gauge; always ap
ply the gasket.
3
2
7
6
5
4
8
Note: Only the ultrasonic level sensor
(SENSORA) can be used!
The tank float for waste water tanks
(WWSENSORA) can NOT be used.
N
ote
!
Check the tightness of all connections
before filling the tank
20 mm
(
3
/
4
”)
Connection at tank bottom, APT100
Open de the connection at the bottom of the
tank by means of drilling to use this connection
Apply a drill of 20 mm.
ENGLISH