24
ENG
PRE-RIDE ALTIMETER CALIBR ATION
Whenever you clear ride data between rides or during a ride, you must re-calibrate your Altimeter before you start riding again.
Otherwise the Altimeter will not function. You could re-calibrate your Altimeter by
●
Recall the Pre-set Altimeter M1 & M2
●
Input a new elevation value
●
Input a new barametric pressure
A) ALTIMETER M1 & M2 OR INPUT ELEVATION VALUES
I. HOW TO RECALL THE PER-SET ALTIMETER M1 & 2?
1) Press both
1
and
2
simultaneously for 2 seconds in SPD/ALT Mode
2) Altimeter M1 will be displayed, press
1
to select and exit to SPD/ALT Mode
3) or press
2
to advance to the Altimeter M2, press
1
to select and exit to SPD/ALT Mode
4) or press
2
to advance to the Manual Input Screen (see Step 6)
(if you want to change the pre-set M1 & M2, see page 12, Section of Altimeter Memory 1 & 2 Setup)
II. INPUT A NEW ELEVATION VALUE
5) Continue from the Step 4 (see above)
6) When the “ft” (or “m”) begins to flash, press
1
to advance to the Elevation Setting
7) The digits “0000” will appear with the right digit flashing
8) Press
2
to scroll to the desired number
9) Press
1
to select and advance to the next digit
10) Repeat for each digit until the final digit
11) Press
1
to select the last digit and return to the SPD/ALT Mode.