BATTERY INSTALLATION
The head of the C-500 uses a common
3032 3v
lithium button cell battery, and
the transmitter uses a common
23A 12v
battery. Replacement batteries are
available at most camera shops and from your Vetta retailer. Under normal usage
a battery should last approximately one year.
NOTE:
Most problems that occur
with cycle computers are caused by dead or weak batteries. If you are having
problems with your computer's operation, check and replace the battery first.
INSTALLATION OF HEAD UNIT BATTERY
STEP 1
Remove the battery cover from the bottom of the computer using a small flat
blade screwdriver.
STEP 2
Install the battery into the battery compartment with the positive (+) side of the
battery facing the compartment door. Be careful when you are installing the
battery not to bend any of the battery contacts.
3032 3v Lithium Battery
AUTO CLEAR BUTTON
Press for total reset of unit.
All stored data will be erased.
!
CAUTION
!
STEP 3
Press the battery cap firmly into place making sure that the rubber o-ring seal
does not get pinched or distorted as this will compromise the waterproofing of
the unit.
INSTALLATION OF TRANSMITTER BATTERY
The transmitter should come from the factory with the
23A 12v
battery installed.
STEP 1
To replace the battery, first remove the battery cap on the top of the transmitter
with a coin. Remove the old battery and dispose of properly.
NOTE:
Check
the inside of the transmitter for corrosion. If corrosion is visible replace the
transmitter with a new unit.
STEP 2
Install a new battery in the transmitter battery compartment with the positive
(+) side facing the opening and reinstall the battery cap.
CAUTION
Make sure that the battery cap is tight to prevent moisture from
entering the transmitter unit. An improperly installed battery can damage the
23A 12v Battery
MAGNET
UP
