Now that you are familiar with the features of your Vetta cycle computer, you are ready to begin programming
the unit specifically for your bike. Take a few minutes to familiarize yourself with the buttons and keystroke
sequences before you proceed to the programming of the unit.
PROGRAMMING THE HEAD OF THE COMPUTER
WARNINGS AND CAUTIONS
!
!
!
CAUTION
Vetta Sports encourages you to ride safely. Wear a helmet every time you ride, use a front
and rear light at night, and always keep your eyes on the road ahead of you.
CAUTION
Vetta cycle computers are sophisticated electronic instruments. Vetta recommends that this
product be installed only by a qualified bicycle retailer. Failure to read these instructions and improper
installation of this device may void the warranty. If you are in doubt about any aspect of the installation or
operation of this product, consult your local bicycle retailer for clarification.
SETTING MILES/HOUR OR KILOMETERS/HOUR
All Vetta cycle computers are capable of being programmed to read out in either miles or kilometers. It is also
possible to change back and forth between miles and kilometers by simply reentering the setting program and
changing your choice of measurements.
NOTE:
If you convert from miles to kilometers and there are more
than 6000 miles on the computer, the unit will reset the total odometer to zero because the conversion is
greater than 10,000km.
The C-06 is a very simple computer to program. All operations are accomplished using a single key.
When you first install the battery in the C-06, the
miles (
m/h
)
and
kilometers (
km/h
)
icons will alternately
flash every 2 seconds.
Select either setting and advance to the wheel size setting mode by pressing the key when the icon that you
desire is visible.
To reenter the programming mode once the unit has been programmed, advance to the
CUMULATIVE
ODOMETER MODE ( SOLID)
and hold the key for 4 seconds to begin the programming sequence.
