PREPARATION
1.Installing batteries/Connecting the AC adaptor
atteries
Battery Remove the battery compartment
compartment cover and insert six batteries(R6P/LR6
/AAsize) into the battery compartment,
taking extreme care that the polarities
plus and minus is observed.
R6P/LR6/AA size
Dry batteries.
Battery compartment cover (batteries are not included)
AC adapter (optional)
Plug the AC adapter to the AC
AC adaptor
adapter socket on the side.
socket
The AC input requirement could
be 110,120,220,230 or 240Volts
(50/60Hz) depending on the area
where used, so please verify that
the adaptor is correct
2.Setting up the scale/balance
△
,
!
CAUTION
Avoid installing the scale/balance in direct sunlight, that may cause discoloration or
malfunctions. Place your scale/balance on a firm weighing table so that the
scale/balance is level. (The scale/balance will not perform accurately when it is not
level.)
Place the scale/balance on the firm surface that is flat and level for an accurate
weighing.
3
WEIGHING
Before weighing
Whenever possible, please allow the balance to warm up for 10 minutes after first
turning to power on, so that the balance will function. Properly and accurately.
Error messages
EEEE: Overload
: Low battery
Calibration may be required before weighing.
Read "CALIBRATION" first and if necessary, calibrate your scale/balance for
accurate weighing.
Weighing procedures
1.
Press [ON/OFF] to turn on the balance.
When power is turned on, all display segments appear on LCD for a few seconds and
finally "0" will appear on the display.
2.
Select the weighing unit with [UNIT].
Press
[UNIT]
to select a weighing unit, eg. "g"
、
" ct "
、
" oz "
、
" tola " …….
Once the unit has been selected, the selected unit will be displayed to the weight value.
3.
Start weighing
If you do not use a container for weighing
Verify the reading is "0". If not, press
[ZERO]
to display "0".
Place objects on the weighing platform to weigh.
When the reading becomes stable, the stable indicator is displayed.
If you use a container for weighing
Place an empty container on the platform.
Wait for the stability indicator to be displayed and press
[ZERO]
.
Place the objects to be weighed in the container.
When the reading becomes stable, the stable indicator is displayed.
FEATURES
Auto shut off (optional).
●
Auto calibration
Auto zero tracking
●
Auto backlight (optional)
Low battery indication
●
g/ct/oz/tola….. conversion(optional)
Lager LCD Display
●
with counting function(optional)
Large square weighting pan
●
Net weight/stability indication
1/120000&1/15000 division available
4
FRH RS-232 OUTPUT FORMAT