2. CAUTION
1.
Hazard or unsafe practice which, if not avoided, may result in MINOR or MODERATE PERSONAL
INJURY and PROPERTY DAMAGE.
2.
READ THE OPERATION MANUAL COMPLETELY BEFORE USING AND THOROUGHLY
UNDERSTAND AND FOLLOW ALL SAFETY INSTRUCTIONS.
3.
This lifter is designed to use with stable uniform load on a solid lever floor. DO NOT use the lifter for
any other purpose than its intended use.
4.
Lifter shall be operated by TRAINED personnel only. OPERATOR shall read “Operation Manual”
completely and thoroughly understand the controls and operation of this equipment BEFORE
operating the lifter.
5.
ALWAYS observe lifter and ALWAYS stay at the controls while the lifter is in motion, RELEASE
controls and STOP lifter immediately if load on lifter appears to become unstable. NEVER leave the
loaded lifter unattended unless the table is in the fully lowered position and the lifter is locked reliably.
6.
DO NOT slid the load on or off the table. The lift may move allowing the load to fall. SEVERE
PERSONAL INJURY and PROPERTY DAMAGE could result.
7.
DO NOT use lifter with unstable, unbalanced or loosely stacked load. Unbalanced loads may become
unstable and fall. SEVERE PERSONAL INJURY and PROPERTY DAMAGE could result.
8.
ALL lifter service must be performed by qualified personnel only.
9.
ALWAYS keep feet, hands and fingers away from casters, load wheels and all moving components.
SEVERE INJURY could result.
10.
ALWAYS perform maintenance and inspections with lifter unloaded.
11.
Prolonged continuous working might cause damage of power pack.
12.
Stop operation if temperature of hydraulic oil is too high.
The lifter is NOT waterproof and is intended to be used in a dry environment.
3. DAILY INSPECTION
Daily inspection is effective to find the malfunction or faulty on the lifter. Check the lifter on the following
points before the operation.
CAUTION
DO NOT use lifter if any malfunction or faulty is found.
(1) Check scratch, bending or crack on the lifter.
(2) Check smooth movement of the wheels.
(3) Check if there is oil leakage.
(4) Check vertical creep of table.
(5) Check the function of brake.
(6) Check if all the bolts and nuts are tightened firmly.
