Vestil BR-M3 Series, Instruction Manual

Page: 6 / 7

Table of Contents Rev. 5/24/2019 BR-M3S Manual
Table of Contents Copyright 2019 Vestil Manufacturing Corp. Page 6 of 7
RECORD OF SATISFACTORY CONDITION (THE “RECORD”)
Record the condition of the rack before putting it into service. Thoroughly photograph the unit from
multiple angles. Take close range photographs of all labeling, post connections, anchoring points, and
hardware. Collate all photographs and writings into a file. Mark the file appropriately to identify it. This
file is a record of the rack in satisfactory condition. Compare the results of each inspection to this record
to determine whether the rack is in satisfactory condition. Purely cosmetic changes, like damaged
surface finish (paint or powdercoat), are not changes from satisfactory condition. However, touchup
paint should be applied to all affected areas as soon as damage occurs.
INSPECTIONS AND MAINTENANCE
At least once per month, thoroughly inspect the rack. Compare its condition to the RECORD . Replace all
components that are not in satisfactory condition:
• Examine the rack for cracked welds and severe rust and corrosion.
• Closely inspect the anchor bolts and the ground or wall around the anchor bolts. The rack should be firmly
anchored to the ground/wall. If the rack wobbles, tighten the anchor bolts. If the bolts cannot be tightened,
install the rack in another location.
• Tighten loose fasteners
• Apply touchup paint to all areas where the finish is damaged. Before applying paint, remove rust with steel wool
and clean the area.
LABELING DIAGRAM
The unit should be labeled as shown in the diagram. However, label content and location are subject
to change so your product might not be labeled exactly as shown. Thoroughly photograph the unit
when you first receive it as discussed in the Record of Satisfactory Condition section of this manual.
Make sure that your Record includes a photograph of each label. Modify this diagram, if necessary, to
indicate labeling actually applied. Replace all labels that are, damaged, missing, or not easily readable
(e.g. faded). Contact the Parts Department online at http://www.vestilmfg.com/parts_info.htm to order
replacement labels. You may also call (260) 665-7586 and ask the operator to connect you to the Parts
Department .
A: Label 287
B: Label 204 (not applied to BR-M3S-W)
A
B