Rev. 5/22/2019
BR-GL Manual
Copyright 2019 Vestil Manufacturing Corp.
Page 3 of 4
RECORD OF SATISFACTORY CONDITION (THE “RECORD”)
Record the condition of the rack before putting it into service. Thoroughly photograph the unit
from multiple angles. Take close range photographs of all labeling and anchoring points. Collate all
photographs and writings into a file. Mark the file appropriately to identify it. This file is a record of
the rack in satisfactory condition. Compare the results of each inspection to this record to determine
whether the rack is in satisfactory condition. Purely cosmetic changes, like damaged surface finish
(paint or powdercoat), are not changes from satisfactory condition. However, touchup paint should
be applied to all areas as soon as damage occurs.
INSPECTIONS & MAINTENANCE
At least once per month, thoroughly inspect the unit. Compare the condition of the rack to the
RECORD
. Replace the rack if it is not in satisfactory condition.
•
Examine the rack/frame for cracked welds and severe rust/corrosion.
•
Closely inspect the anchor bolts and the ground around the anchor bolts. The rack should be
firmly anchored to the ground. If the rack wobbles, tighten the anchor bolts. If the bolts cannot be
tightened, install the rack in another location.
LABELING DIAGRAM
The unit should be labeled as shown in the diagram. However, label content and location are
subject to change so your product might not be labeled exactly as shown. Thoroughly photograph
the unit when you first receive it as discussed in the
Record of Satisfactory Condition
manual. Make sure that your Record includes a photograph of each label. Modify this diagram, if
necessary, to indicate labeling actually applied. Replace all labels that are, damaged, missing, or
not easily readable (e.g. faded). Contact the
http://www.vestilmfg.com/parts_info.htm
to order replacement labels. You may also call (260) 665-
7586 and ask the operator to connect you to the
A: Label 287
B: Label 204
A
B
