VESTEL 39FB7100, Operating Instructions Manual

Page: 75 / 115

English - 74 -
No . If an apartment installation system is
available in your apartment, select Yes and
press OK to proceed. Shifting is processed
in accordance with the IF frequency values.
You can also select one of the Manual
channel scan or Automatic channel scan
procedures by using the Preferred Scan
option.
If you select Standard as Install Type and
press OK , Antenna Type menu will be
displayed first. You can select Antenna Type
as Direct , Single Satellite Cable or DiSEqC
switch by using “ ” or “ ” buttons.
• Direct: If you have a single receiver and a
direct satellite dish, select this antenna type.
Press OK to continue. Select an available
satellite on the next screen and press OK
to scan for services.
• Single Satellite Cable: If you have multiple
receivers and a single satellite cable system,
select this antenna type. Press OK to
continue. Configure settings by following
instructions on the next screen. Press OK
to scan for services.
• DiSEqC switch: If you have multiple
satellite dishes and a DiSEqC switch ,
select this antenna type. Press OK to
continue. You can set four DiSEqC options
(if available) on the next screen. Press OK
button to scan the first satellite in the list.
TKGS (Türksat Kanal Güncelleme
Sistemi) installation
If desired, you can start a TKGS Installation
if the Satellite broadcast search option is
turned on. Before the satellite search starts, a
menu will be displayed where you can select
to start a TKGS Installation . Set the Install
Type as Operator and than set the Satellite
Operator as TKGS . Then press the OK
button to start TKGS Installation . Set your
antenna type as described abow. You can
select to install HD or SD channels during the
installation. This selection can be done later
too using the Preferred List option under the
Installation>TKGS Installation menu. The
selection will be activated, after switching the
TV off and back on again or after a manual
update as described below.
If wanted
TKGS Installation can be applied
manually after the First Time Installation .
Press the Menu button. Highlight Installation
and press OK . In the sub menu highlight
Satellite Settings and press OK . Then select
Antenna Installation . After the antenna
type is selected and other satellite settings
are made press the RED button to start a
TKGS Installation .
The second way to apply TKGS installation
manually after the First Time Installation
is starting an update. To do this press the
Menu button and select Installation > TKGS
Installation > Start Update . But to be able
to do so the Satellite Settings should be
done first.
To use the update options of TKGS
TKGS feature keeps your satellite channel
lists up-to-date in three different ways.
Standby: While going into standby mode,
the TV controls the TKGS table version
number whether it is the last version or not.
If any changes are detected, TV starts to
update. On the next switch-on a message
will be displayed to inform the user about
the changes.
Background: When a channel is opened
which isn’t defined in the TKGS channel
lists, the TV controls the TKGS table version
number whether it is the last version or not.
If any changes are detected, TV starts to
update. When the update is completed a
message will be displayed to inform the user
about the changes.
Manual: An update can be started manually
any time. Press the Menu button. Highlight
Installation and press OK . In the sub menu