VESTEL 28HB5100, Operating Instructions Manual

Page: 44 / 73

English - 43 -
To change source: Press the middle of the
button in twice(for the second time in total),
the source list will appear on the screen. Scroll
through the available sources by pushing the
button up or down.
To turn the TV off: Press the middle of the
button in and hold it down for a few seconds,
the TV will turn into standby mode.
To turn on the TV: Press the middle of the
button in, the TV will turn on.
NOTES:
• If you turn the TV off, this circle starts again
beginning with the volume setting.
• Main menu OSD cannot be displayed via
control buttons.
Operation with the Remote Control
Press Menu button on your remote control to
display main menu screen. Use the directional
buttons to select a menu tab and press OK
to enter. Use the directional buttons again
to select or set an item. Press Return/Back
button or Menu button to quit a menu screen.
Input Selection
Once you have connected external systems
to your TV, you can switch to different input
sources. Press Source button on your remote
control consecutively to select the different
sources.
Changing Channels and Volume
You can change the channel and adjust
the volume by using the /- and
Programme +/- buttons on the remote.
Inserting the Batteries
into the Remote
Remove the back cover to reveal the battery
compartment. Insert two size AAA batteries.
Make sure the (+) and (-) signs match
(observe correct polarity). Do not mix old
and new batteries. Replace only with same
or equivalent type. Place the cover back on.
Connect Power
IMPORTANT : The TV set is designed to
operate on 220-240V AC, 50 Hz socket.
After unpacking, allow the TV set to reach
the ambient room temperature before you
connect the set to the mains. Plug the power
cable to the mains socket outlet.
Antenna Connection
Connect the aerial or cable TV plug to the
AERIAL INPUT (ANT) socket or satellite
plug to the SATELLITE INPUT (LNB)
socket located on the back of the TV.
satellite
REAR
OF
THE TV
aerial
or
cable