5
PROGRAM INPUT SECTION
1
8
9
10
2
7
3
4
5
6
11
○
6
EQUALIZER (LOW 80Hz +6dB
〜
-24dB, Shelving type)
Adjusts the LOW freguency level for each PGM
channel.
○
7
EQ CUT SWITCH ( HI, MID, LOW )
Cuts off the each frequency range by 24dB. The
EQUALIZER volume dose not function when this
switch is set to "CUT".
○
8
EFFECT SWITCH
Used to send the signal to the external effect processor
connected to the effect SEND/RETURN.
○
9
P.F.L.. SWITCH
Used to send the signal from the PGM channel to the
monitor section for headphone monitoring.
○
10
OVERLOAD INDICATOR
Lights when input level is over.
○
11
INPUT FADER
This is a detachable fader for the ease of
replacement. Replace with IF-17 when it is worn
out.
HOW TO REPLACE THE FADER
●
Remove four screws which is holding the fader
panel.
●
Remove the fader unit.
●
Carefully remove the multi-cable connector from
the fader unit.
●
Insert the connector to the new fader unit.
●
Place the fader unit and tighten the screws.
○
1
INPUT SELECTOR
Used to select input (2 line or 1 phono) to be sent to
each PGM channel.
○
2
TRIM CONTROL
Adjusts the input level of each channel. Set INPUT
FADER to 7-8 position, adjust the TRIM CONTROL
so that the sufficient signal is fed without distortion.
○
3
BALANCE CONTROL
Adjusts the stereo balance for each PGM channel.
Can be used for adjusting the unbalanced stereo
image. Clockwise rotation from center position
increases the volume of R over L channel. A counter
clockwise rotation increases the volume of L
channel over R.
○
4
EQUALIZER (HI 10Hz +6dB
〜
-24dB, Shelving type)
Adjusts the HI frequeny level of each PGM channel.
○
5
EQUALIZER (MID 1KHz +6dB
〜
-24dB, Peaking type)
Adjusts the MID frequeny level of each PGM
channel.
+
+
+
+
角
4
点のネジを
外す。
マルチケーブル
コネクターを抜く
Remove four
sarews
Remove the multi
cable connector
