Subject to modifications.
© Vestamatic GmbH
9/10
G
H O M E · VL-SMI-230-45
Art.-Nr.:
8900 001 GB 3117 A04 • Vestamatic GmbH • Dohrweg 27 • D-41066 Mönchengladbach
• www.vestamatic.com
Motor – RESET
1. Clear – LED status
Clear the installation tool LED-status.
Keep the RESET button
pressed till
the LEDs turn off.
2. Delete the limit position settings
of the motor
Press the RESET button
, till the
LEDs start blinking.
The LEDs keep blinking as long as the
motor reset process is in progress.
When the RESET process is finished,
the LEDs turn off, the motor limit posi-
tions have been cleared, and can be set
again.
The motor will shortly move during the
RESET sequence.
RESET
NOTE!
Tubular motor might be switched off before reaching the limit position:
Extraordinary large increases of load (anti-block-function) – obstacles,
sunshade system keeps jamming, tubular motor is overloaded.
Remedy action:
– Removing the obstacle.
– Check the mechanical parts of the sunshade system.
– Use the correct tubular motor (rated torque – tractive power) according the
spezification of the sunshade system.
I
UP
DOWN
red
Intermediate
position
green
yellow
Save intermediate position
– Before setting the intermediate posi-
tion, the upper and lower limit position
should be set and confirmed.
– Press the button
or
= self-lock-
ing. Simply press the opposite button to
stop the motion.
– Press the button “intermediate position”
shortly.
– The yellow LED
starts blinking as
long as the setting process is in pro-
gress.
– The yellow LED lit solid if the process
is finished.
– The motor will give a feedback (short
DOWN / UP movement) to confirm that
the installation procedure has ended.
– When an intermediate position is pro-
grammed, the motor reaction is de-
pendable of how long the UP / DOWN
button is pressed.
– Press the button
or
short = inter-
mediate position.
– Press the button
or
long (> as
1 sec.) = overrun the intermediate po-
sition.
– The intermediate position can be
change / overwritten at any time.
Option: start with lower limit position setting
– Hold down the button
till motor stops automatically
due to obstacle detection. Lower physical limit position is
now set.
– Hold down the button
till motor stops auto matically
due to obstacle detection. Upper physical limit position
is now set.
– The motor needs the following complete movements
(figure 7) to memorize the limit posi tion. (Hold down
the button
or
to move the motor in the request-
ed direc tion). The motor will give a feedback (short
up / down movement) to confirm that the installation pro-
cedure has ended.
Physical – Physical
Advice: start with upper limit position setting
– Hold down the button
till motor stops auto matically
due to obstacle detection. Upper physical limit position
is now set.
– Hold down the button
till motor stops automatically
due to obstacle detection. Lower physical limit position is
now set.
– The motor needs the following complete movements
( figure 6) to memorize the limit posi tion. (Hold down
the button
or
to move the motor in the request-
ed direc tion). The motor will give a feedback (short
up / down movement) to confirm that the installation pro-
cedure has ended.
UP
DOWN
red
Change turning
direction
green
yellow
figure 6
figure 7
