Vessel Stat-Clean SH Series, Instruction Manual

Page: 33 / 40

33
Installation
Installation
WARNING
PROHIBITED
Do not use the eraser in the following places.
There is a risk of explosion or fire.
* Where explosion-proofing is required
* Where corrosive gases, flammable or explosive gases are handled"
CAUTIONS
REMEMBER
Consider the surrounding environment when choosing the installation location.
* Install the eraser indoors where it is not subject to wind, rain or direct
sunlight.
* Avoid places where water or oil could get on the eraser.
* Avoid places where the eraser could be subject to strong vibration or shock.
* Use the eraser within a temperature range of 5 to 55 °C, and humidity range
of 25 to 85 %."
Installation place
* Install the eraser indoors where it is not subject to wind, rain or direct sunlight.
* Avoid installing the eraser where it may be wet by water or oil or where
it may subject to dew condensation or sharp temperature fluctuation.
* Avoid installing the eraser in a place where it is subject to strong
vibration or shock.
* Use the enclosed brackets to install the bar unit onto devices.
Ambient temperature and humidity
* Use the eraser within a temperature range of 5 to 55 °C,
and humidity range of 25 to 85 %.
Atmosphere
* Do not use the eraser in an environment requiring explosion-proofing.
* Do not use the eraser where corrosive, flammable or explosive gases are handled.
* Use the eraser in a normal air atmosphere.
Power supply and air
* The eraser requires a 24 VDC ± 5 % power supply and clean air or nitrogen up to 0.5 MPa.
* Use the eraser where these resources can be wired and piped.
Installation clearance
Refer to the distance between the metal body and each
bar unit shown below in the following cases.
* When installing the eraser near the grounding metal
* When installing multiple bar units closely