Switching on your Vertu phone
14
SWITCHING ON YOUR VERTU PHONE
If your battery requires charging, a
b a t t e r y l o w
message is displayed when you first switch on your
Vertu phone. Refer to “Charging your battery” on
page 33 for more information.
Contact with the antenna affects call quality and
may cause the phone to operate at a higher power
level than otherwise needed. Avoiding contact with
the antenna area when operating the phone
optimises the antenna performance and battery life.
ENTERING YOUR PIN CODE
Depending on your SIM card settings, you may be
prompted to enter a PIN (Personal Identification
Number) code when you switch on your Vertu
phone. This code is used to protect access to your
SIM card and is independent of your Vertu phone.
If you used your SIM card in another phone
previously, the code will be the same.
>
Press and hold the
P O W E R
key (
01
) for
approximately four
seconds to switch on
your Vertu phone.
>
Your Vertu phone has
an internal antenna
located inside the top-
rear panel (
02
). Do not
touch the antenna
unnecessarily when
phone is switched on.
>
Use the
N U M B E R
keys
to key in your PIN code.
>
Press
o k
.
It is recommended that you activate both
the PIN code and security code to help
prevent unauthorised use of your SIM card
and your Vertu phone. Refer to the
“Security” chapter of the User manual for
more information.
01
02
quickguide.book Page 14 Thursday, August 21, 2003 3:43 PM
