Vertiv NetSure SCC, User Manual

Page: 13 / 36

Vertiv
| NetSure™ SCC Controller User Manual (UM1M520HNA) | Rev. H
13
Table 2:
System Power Rated Capacity
Get/Set Field
Get Total System Rectifier Power (W)
Get Total System Battery Power (W)
Table 3:
System Status
Get/Set Field
Get System Status (Normal, Alarm Active)
Get
Battery State-of-Charge (% of Total Available).
This is 0 if there are no BBUs.
Get AC Status (on/off)
Get
Incoming AC Voltage (V) (average of non-zero
values reported by all rectifier units)
Get
System DC Output Voltage (mV) (average of non-
zero values reported by all rectifier and BBU units)
Get
System DC Output Current (A) (average of non-
zero values reported by all rectifier and BBU units)
Get DC Output Power (W)
Get
Estimated Battery Hold-Up Time (Seconds) for All
Batteries in the System
Get
Estimate Time to Fully Charge Batteries (Minutes)
(maximum of the times reported by the BBUs)
Table 4:
System Control
Get/Set Field
Get/Set All Rectifiers Enabled
Get/Set All Batteries Enabled
Set Reset System
Set
ECO-Mode Enable/Disable
Enable/Disable ECO mode. (Individual rectifiers
and BBUs can only be enabled or disabled when
ECO-mode is disabled).