VERTIMA railoc, Assembly And Maintenance Instructions, Page: 13 / 21

13/21
Assembly and maintenance instructions railoc
2.4 Electrical installation
The r ailoc is internally pre-wired so that only the two or three plug connections have to be
joined together on the device, with optional inspection limit switch.
Pre-assembled cable extensions are available in 10m lengths.

Switch the system off by operating the main switch
 Uncoil the associated supply cables and lay them, starting at the controller
 Ensure that the cable routing is clean, which minimizes the risk of damage to the cables.
Use loop dowels or cable duct.

If necessary, extend the cables until you reach the r ailoc
 Connect the two or three plug connections
 Go to the controller and lay the pre-assembled ends of the cables to the terminal block
area in the controller
 Using the r ailoc circuit diagram in the appendix, connect the individual wires to the
corresponding terminal blocks according to the specifications of your control
manufacturer

Ensure that the wiring has been carried out correctly.