Vertical Edge 9200 Series Phone
User Guide
53
9.
PBX,
C
ENTREX
&
ISDN
FEATURES
9.1 Access PBX or Centrex features
The Summit system has been designed to operate with a host
PBX system or Centrex services from your service provider. The
Summit system connects to a host with analog CO lines.
When accessing a CO line, the phone will act as an extension of
the host, allowing access to the host system features using the
host dial codes. While on a call, use the
Flash
feature to transfer
calls to other host extensions or access features of the host.
The Flash feature may be used on other CO lines to regain dial
tone from the CO line without relinquishing control of the CO line
to place another call.
To access PBX or Centrex features while idle:
Lift the handset,
Select/dial access a PBX/Centrex CO line,
Dial PBX/Centrex feature code.
To access PBX/Centrex features while on a PBX/Centrex CO
line:
Select the
Flash
soft button or the
FLASH
button, in case of
Edge 9200 8-Button, make {Flash} as Flexible button (Code
is 94),
After receiving new dial tone, dial the PBX/Centrex feature
code.
9.2 Access the ISDN Network
9.2.1 Using the Keypad facility to access ISDN features
Access to certain features of your ISDN services requires that
dialed digits be sent to the ISDN as data and not tones. In this
case, dialed digits are sent as ‗Keypad messages‘.
A Keypad Facility button must be assigned using the
Flex
Button program
procedures (the code is 89). Once active, dial
into the ISDN for services; however, actions other than dialing
will deactivate the Keypad Facility operation.
To activate Keypad Facility operation:
Press the
KEY PAD FACILITY
button to switch to keypad mode,
Dial as desired.
