Vertical Comdial DX-80, Technical Manual

Page: 26 / 322

O
VERVIEW
> P
ROGRAMMING A
N
EW
S
YSTEM
DX-80 Programming Manual
- 26 -
9. Specify the reroute destination (extension number).
10. Set the UCD Voice Announce (VA) groups.
Details on how to perform these tasks are included in Section 8, Programming Uniform Call Distribution (UCD)
Groups . The DX-80 provides programmable features that allow you to establish these various settings.
1.3.6 SETTING UP VOICE MAIL
You can set up the DX-80 to interface with either an external, analog third party voice mail system or to the internal
digital DX-80 Voice option. If you use analog voice mail, you must assign system ports to the voice mail system.
If you use the digital in-skin voice mail, you do not use analog system ports and therefore do not have any port loss.
To set up voice mail, perform the following tasks for each tenant group.
1. Program third-party voice mail on analog ports.
Or,
2. Program the optional, internal, digital voice mail.
Details on how to perform these tasks are included in Section 9, Programming Voice Mail . The DX-80 provides
programmable features that allow you to establish these various settings.
1.3.7 SETTING UP EXTENSIONS
Once you have set up the system, CO line, call handling, toll restriction, UCD (if applicable), and voice mail (if
applicable), the next task in setting up a new system is to program the extensions. To program the extensions in the
system, perform the following steps for each extension in the system.
1. Assign a user name and password to the extension.
2. Assign the extension to a tenant group.
3. Assign the extension to a pickup group.
4. Assign the extension to a paging group.
5. Assign a class of service to the extension.
6. Set up the Monitor classification.
7. Set up intrusion—active, accept, and tone.
8. Set up warning tones, incoming call drops, outgoing call drops.
9. Set up Off Hook Voice Announce (OHVA).
10. Enable/disable paging.
11. Set up external call forward.
12. Set up SMDR output.
13. Assign RAD devices.
14. Enable/disable recording.
15. Set up port type.
16. Set up CO line assignment
17. Set up receive assignment.
18. Set up extension ring level.
19. Assign feature buttons.