19
Defiant
®
1975 Non-Catalytic / Catalytic Woodburning Stove
30005220
adjust the leg levellers
Lift the stove slightly so there is no weight on the leg
while making the adjustment.
Reverse the Flue collar (if necessary)
Reverse the flue collar by removing the two screws that
attach it to the back of the stove. Be sure the gasket
around the flue collar opening is in position when you
screw the collar back onto the stove.
adjust air Deflector
If you have the optional fan kit, you may decide to
adjust the air deflector to blow heat across the top of
your stove. (Fig. 24) Loosen the two (2) screws on each
side and raise or lower the deflector. After adjustment,
tighten the screws.
attach Flue collar heat Shield
waRNiNg:
The flue collar heat shield must be attached
to the Defiant stove. Use four #10 sheet metal screws
supplied to secure the flue collar heat shield to the rear
of the stove. (Fig. 24)
ST540
Assembly
handle
11/00
ST540
Fig. 26
Assemble the front door handle.
DEFIANT
ST539
attach
thermostat
handle
11/00
ST539
Fig. 25
Attach the thermostat handle.
ST1180
flue collar heat shield
Sheet
Metal
Screws
Sheet
Metal
Screws
Flue Collar
Heat Shield
ST1180
Fig. 24
Install flue collar heat shield.
waRNiNg:
Flue collar heat shield must be installed.
attach the Damper handle
Use the 1/4” -20 x 3” screw to attach the damper handle
to the damper stub on the left side.
attach the primary air Thermostat handle
The primary air thermostat handle is the smaller of the
two black handles. Secure the handle to the stub on
the right side of the stove with an 8-32 x 2” slot head
machine screw. (Fig. 25)
assemble the Removable insert handle
The ceramic removable insert handle opens and closes
the front doors. Remove after each use, and store it in
the handle holder behind the right front leg. Assemble
the handle by passing the 3
C\,
" screw through the
ceramic shaft and into the bright metal nub. (Fig. 26)
Tighten carefully until snug.
Air Deflector
Air Deflector
