8
2003135
Figure 21 -
Attach rear shroud cover plate to the rear shroud.
ST372
Attach rear
skirt cover
5/19/00 djt
A
Rear Shroud
Cover Plate
A
RNVOD
These instructions are for stoves with serial numbers starting
at #1457 (RNVODRN), #1944 (RNVODRP).
1. Loosen the four (4) phillips head screws which secure the
rear shroud to the stove sides. (Figure 22)
ST713fan remove shroud
radiance
11/99
Rear Shroud
Assembly
Figure 22
- Remove rear shroud.
4. Attach the snapstat housing to the snapstat bracket with
two (2) sheet metal screws and one (1) #8 star washer.
(Figure 19)
5. Attach the snapstat bracket, with the snapstat assembly
attached, to the horizontal surface on the inside of the
rear shroud. Use a sheet metal screw. There are predrilled
holes at each corner of the panel for this. The vertical part
of the snapstat bracket should be 3/16” back from Edge ‘A’.
(Figure 19)
6. Attach the fan assembly to the rear shroud using two (2)
1/4-20 x 1/2” hex head bolts, two (2) 1/4”-20 nuts and one
(1) 1/4” star washer. (Figure 19)
7. Reattach the stove’s rear shroud.
8. Reattach the rear shroud cover plate by fastening it to
the rear shroud as shown in Figure 21. The top edge of
the cover plate goes inside the rear shroud. Reinstall and
tighten the six (6) sheet metal screws around the draft
hood opening. (‘A’, Figure 21) Use two (2) screws from
the fan kit to fasten the rear shroud to the fan shield. (‘A’,
Figure 21)
9. Plug the fan cord into a standard grounded 110 volt
household outlet.
ST669
RUVSOD
attach fan to bracket
7/01
Snaptstat
Wire
Rheostat
Wire
Fan
Bracket
Finger Guard
Figure 23
- Attach the fan assembly to the fan bracket.
5. Connect snapstat leads. Disconnect the snapstat module
from the leads inside the snapstat bracket. (Figure 24)
Bend open the snapstat bracket. Use needle nose pliers
to remove the black plastic grommet from the bracket.
Discard the bracket. Insert the grommet and wires into the
large hole at the bottom right corner of the inner shroud.
Feed the snapstat wire leads through the grommet into
the stove interior. Connect the two (2) wires to the two (2)
snapstat extension leads attached to the inner shroud or,
on some models, between the inner and outer shroud.
ST640
RUVSOD
snapstat
7/01
Snapstat Bracket
Snapstat Module
Pinch Grommet
to Remove
Figure 24
- Remove the snapstat and grommet form the bracket
and insert the grommet into the inner shroud.
2. Carefully pull the shroud assembly away from the rear of
the stove.
3. With the rear shroud assembly in the upright position, set
the bottom of the shroud on a padded surface to prevent
scratching the surface. Unfasten the four phillips head
screws which attach the outer shroud to the inner duct
assembly.
4. Attach the fan assembly to the fan bracket provided in the
finish bag using the #10 sheet metal screws provided in
fan kit. Do not remove finger guard screws. (Figure 23)