18
2003135
B
A
A
B
ST593
replace cover plate
Insert the flange
behind the lip
of the shroud
opening.
Figure 58 -
Reattach the cover plate and secure the rear shroud
to the firebox draft hood assembly.
SNV30
These instructions are for stoves with serial numbers starting
at #5251 (SNV30RN), #5484 (SNV30RP).
1. Attach the fan assembly to the fan bracket provided in the
log box. Use #10 sheet metal screws provided with fan
kit. Do not remove finger guard screws. (Figure 59)
ST670a
RUVSOD
snapstat
7/01
Snapstat Bracket
Snapstat Module
Pinch Grommet
to Remove
Figure 60 -
Remove the snapstat and grommet from the bracket.
ST669
RUVSOD
attach fan to bracket
7/01
Snapstat
Wire
Rheostat
Wire
Fan
Bracket
Finger Guard
Figure 59
- Attach the fan assembly to the fan bracket.
3. Disassemble the inner shroud from the outer shroud by
removing the four screws, two on each side.
4. Place the grommet provided in the parts bag assembly on
the inner shroud. Run the snapstat extension assembly
leads through the grommet toward the firebox. (Figure 61)
2. Connect snapstat leads. Disconnect the snapstat module
from the leads inside the snapstat bracket. (Figure 60)
Bend open the snapstat bracket. Use needle nose pliers
to remove the black plastic grommet from the bracket.
Discard the bracket. Connect the two wires to the two
snapstat extension leads provided with the parts bag
(wires with the sleeve).
ST720
attach snapstat
8/02
Left Air Duct
Inner
Shroud
Grommet
Fan
Figure 61
- Attach snapstat wire assembly to inside of inner shroud
with clamp screws.
5. Assemble the inner shroud to the outer shroud using
previously removed screws.
6. Position the fan assembly so the ducts slide between the
inner and outer shroud. The inner shroud should engage
with the two slots in the ends of the bracket so the bracket
and shroud are interlocked. (Figure 62) Secure the bracket
with the four sheet metal screws provided in the finish bag.