5
2003135
RVF33
1. Remove the rear shroud. Use work gloves to protect
against sharp edges. Loosen the two (2) screws on each
side just enough to disengage the shroud panel from the
sides of the stove. (Figure 10)
2. Remove the switch box. (Figure 10)
•
Remove the sheet metal screw and washer from the
left side (as you face the rear of the stove) of the switch
box.
•
Remove the phillips screw and washer from the right
side of the switch box.
•
Remove the hole plug from the switch box.
Kt247
RVF remove rear shroud
C
A
B
Figure 10
- Remove rear shroud and switch box.
ST150
rdv attach snapstat
10/99
Heat Shield
Use Lower Hole
Figure 12 -
Attach snapstat bracket.
T'STAT
OFF
ON
ST151
rdv install rheostat
10/99
Rheostat Knob
Retaining Nut
Rheostat
Figure 13
- Install rheostat into switch box.
6. Install the rheostat into the switch box. Feed the fan
rheostat wire harness through the cut out in the rear
shroud. Insert the rheostat control shaft through the switch
box hole while aligning the locator pin with the smaller
hole. Install the retaining nut and knob onto the control
shaft. (Figure 12)
7. Reinstall the switch box on the rear shroud using the
original screw(s). Be sure the wire harness runs down
the inside face of the shroud panel.
8. Reinstall the rear shroud and tighten the four (4) screws.
Figure 11
- Attach fan to RVF33.
RVF33 attach blwr&snpstat
Rheostat
Snapstat
#8 Star Washer
Sheet Metal
Screws
#8 Star Washer
1/4-20x3/4 Hex
Head Screws
5. Attach the snapstat. (Figure 11) Use the two (2) sheet
metal screws and single #8 star washer to secure the
snapstat to the back of the firebox.
3. Install the fan mounting bracket to the blower assembly
with two (2) 1/4-20 X 3/4” hex head screws and one of
the 1/4” star washers. (Refer to Page 1)
4. Secure the fan assembly to the bottom plate through the
mounting bracket with the other two (2) 1/4-20 x 3/4” hex
head screws and the remaining 1/4” star washer. (Figure
10)