3
EN
⚠
The corresponding plug socket is protected against reverse polarity. Therefore, the 10-pole
connector of the ribbon-cable will only fit in one direction into the module. (See "Figure 1:
quadroPOL rear") The supplied ribbon-cable is color-
coded at the -12 volts position. Note, that this may differ
from other manufacturers. Therefore, only use the
supplied ribbon-cable to connect quadroPOL to your
frame’s system bus!
3. Connect the ribbon-cable’s 16-pole connector to an empty plug-socket
of your frame’s system bus.
Make sure the color-coded side of the
cable points towards -12 volts!
⚠
Connecting the ribbon-cable with reverse polarity can
lead to damage of your module or other modules when
powering the system! Double-check the connections
before continuing – safe is safe!
4. Mount quadroPOL to your modular frame using the supplied screws. To
protect the unit’s surface from scratches, use the supplied flat plastic
washers.
5. Reconnect the power cord to your frame and switch on the power-
supply. quadroPOL is now ready to operate.
-12 V
Figure 1: quadroPOL rear