Vermeiren NAVIX, Instruction Manual

Page: 17 / 44

Navix
2012-04
Page 15
2.10 Seat cushions
The seat cushion can be removed or mounted
with the velcro strips on the seat frame plate
.
2.11 Back rest cushions
L L L L
WARNING: Risk of injury – Check that all straps are secured with Velcro.
The back rest cushions can be removed or
mounted with the velcro strips on the backrest
velcro straps .
The back can be adjusted in its flexibility, so the
back of the user is supported differently.
1. Remove the back rest cushion with the velcro . Pull the back rest cushion on the
frontside to the front, back rest cushion comes from the velcro straps . Pull the
back rest cushion on the back side backwards. Now you can see the suspension
system with straps that can be adjusted independently.
2. Loosen the velcro closures of the respective straps .
3. Pull the respective strap to the desired position, the tension of the individual belts
can be varied and the desired support of the back can be set.
4. Replace the back rest cushion .
2.12 Transfer in and out the electric wheelchair
L
L L
L
CAUTION:
In case you cannot perform the transfer in a safe manner, ask
someone to assist you.
L L L L
CAUTION:
Risk of injury – Do not use the joystick, footplates, arm supports as
support.
L L L L
CAUTION:
Risk of tipping over of the wheelchair – Do not stand on the foot
plates.
1. Park the electric wheelchair as close as possible to
the place where you want to transfer.
2. Check that the operator control is switched off.
Make sure that the wheelchair is NOT in freewheel
mode.
3. Fold the foot plates upwards to prevent standing on
them.
4. If the transfer is on the side of the wheelchair, fold
the arm support on that side away.
5. Transfer to / from the electric wheelchair.