Inovys II-E
2017-02
Page 20
3.3 Mounting
backrest
L
WARNING:
Risk of injury - Make sure that the ring of safety pin
Ⓐ
is firmly
secured.
After you have taken the wheelchair out of the original packaging, push the backrest to the
back into the 90° position. Guide the safety pin
Ⓐ
into the appropriate socket to attach the
motor
Ⓑ
, which is located at the backside under the seat.
Check that no cables are squashed.
3.4 Adjusting the seat height and seat angle
L
WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
L
WARNING:
Risk of injury - Self-locking nuts are only to be used once or are to be
secured with an additional screw locking device.
L
WARNING:
Risk of injury - Adjust the brakes if necessary after adjusting the seat
height and seat angle.
L
WARNING:
Risk of injury - Check that the seat heights are mounted in the same
position on both sides.
L
WARNING:
Risk of tipping over - When the driving wheels are adjusted, the
position of the wheels are altered.
The seat height of the Inovys II-E multiposition wheelchair is adjustable in 3 positions in
steps of 35 mm. The seat height can be adjusted by moving the front tube
Ⓐ
, attachment
plate motor
Ⓑ
and rear wheel plate
Ⓒ
in different positions. These components you can find
below the seat frame.
Seat height
Part
Ⓐ, Ⓑ, Ⓒ
460 mm
Hole 1
495 mm
Hole 2
530 mm
Hole 3
Table 2: Seat heights
Summary of Contents for Inovys II-E
Page 1: ...VERMEIREN Inovys II E I N S T R U C T I O N M A N U A L...
Page 31: ......