Express VB
2014-03
Page 22
2.22 Thermal fuse
To protect the motor against overload, on the
back of the wheelchair topside of the first battery
housing, there is a thermal safety mechanism
that will automatically cut off the motor to prevent
overheating and thus rapid wear and tear or
breakdowns. This can occur if you go up or down
slopes that exceed the maximum gradient
indicated. Nominal loads exceeding the
maximum could also trigger the safety
mechanism.
To be able to use the electric wheelchair again, remove the overload and wait till the motor
has cooled down. Then gently press the thermal safety mechanism back in. Your wheelchair
is now ready for use again.
3
Installation and adjustment
The instructions in this chapter are for the specialist dealer only.
The Express VB has been designed as a rear wheel drive electric wheelchair.
L
WARNING:
Risk of unsafe settings - Use only the settings described in this
manual.
L
WARNING:
Risk of tipping over - Variation allowed adjustments can still change
the stability of your wheelchair (tilt back or sideways).
3.1 Tools
To set up the wheelchair the following tools are needed.
Wrench set n° 10
Allen keyset n° 4 to n° 5
3.2 Manner
of
delivery
The electric wheelchair shall be delivered with:
Framework with armrests, operator unit, rear and front wheels, seat and backrest
1 pair of footrests
2 separate drive bat battery housings, 2 x drive motors
Battery c manual battery charger
Electronics
Tools
Operator unit + manual operator unit
Accessories
Before use, check that everything is included and that no products are damaged (example
by transport, ...). Please note that the basic configuration may differ in different European
countries. Contact your specialist dealer.