D200 30°
2014-10
Page 3
1. Pull lever
on both sides towards the
handgrip
to adjust the backrest.
2. The pin
Ⓐ
comes out the groove of the toothed
plate
Ⓑ
.
3. Pull both back tubes backwards continuously
to the desired position (4 different positions: 5°
- 15° - 25° - 35°).
4. Check that the pin
Ⓐ
is well fixed in the groove
of the toothed plate
Ⓑ
.
If your wheelchair features drum brakes, the levers
are used as brakes.
2.2 Mounting or removing of pushbar
(add to manual D200)
L
WARNING:
Risk of injury - Make sure that the starknobs
Ⓐ
are tightened.
L
WARNING:
Risk of injury - When equipped with the pushbar, the pushbar shall
always be mounted (
→
to increase the stability of the backrest).
The mounting of the pushbar
Ⓑ
is done as follows:
1. Mount the pushbar
Ⓑ
with the starknob
Ⓐ
in the left handgrip.
2. Swing the pushbar
Ⓑ
to the right.
3. Mount hook
Ⓒ
over the right handgrip
Ⓓ
as shown on the drawing. Use holes
or
to
adjust the tension of the backrest.
To take off the pushbar:
1. Loosen the starknob
Ⓐ
on the right handgrip.
2. Remove hook
Ⓒ
from the right handgrip
Ⓓ
.
