Carpo 3, Carpo 4, Carpo 3D, Carpo 4D
2021-05
Assembly
and adjustments
Installation manual
- 6 -
EN
NL
PL
CS
3.2
Adjusting the scooter to the user
3.2.1 Seat height adjustment
The seat can be adjusted in 2 different seat heights (distance: 25 mm).
1. Remove the seat.
2. Remove the bolt (3) and nut (5).
3. Move the adjustment bar (1) upwards/downwards in the receiver (6), and place in a
comfortable seat height.
4. Retighten the adjustment bar (1) with the bolt (3) and nut (5).
5. Replace the seat.
6. Make sure that the seat is locked securely.
3.3
Changing the batteries
Risk of injuries and damage
•
The batteries must only be replaced by trained personnel
•
Do not come into contact with the acid from the batteries.
•
Replace the batteries in a well-ventilated room.
•
Make sure that the ventilation holes of the battery housing are free from any contaminations.
•
First read the charging instructions in the user manual before charging the batteries.
Always change both batteries at the same moment to prevent rapid degeneration.
The wiring and charger are well-situated in the scooter. Do not attempt to relocate the wiring by
yourself. The improper installation of the wiring may result in pinched wires between the battery
box, which cause failure to the electronic system of your scooter.
Make sure that the battery cables are connected to the right battery.
Risk of injury
•
Make sure that all movable parts are assembled properly.
CAUTION
1 = Adjustment bar
2 = Washer
3 = Bolt
4 = Washer
5 = Nut
6 = Receiver
1
3
5
6
2
4
WARNING
