Carpo 3, Carpo 4, Carpo 3D, Carpo 4D
2021-05
Assembly
and adjustments
Installation manual
- 8 -
EN
NL
PL
CS
3.4.2 Rear tyre Carpo 3, Carpo 3D ; all tyres Carpo 4, Carpo 4D
DISMANTLING
1.
Unscrew and remove the 4 screws that attach the wheel to the flange.
2.
Let the air out of the wheel by lightly pressing the pressure pin on the valve.
3.
Unscrew the 5 screws of the rim. Separate the rim sides.
ASSEMBLY
1.
Insert the partly-filled inner tube into the tyre.
2.
Connect the two sides of the rim on the tyres and fasten them again with the 5 screws.
3.
Put the valve through the hole in the rim.
4.
Put the wheel back on the flange and secure this connection with the 4 screws. Inflate the
wheel to the recommended tyre pressure.
Check all around on both sides that the tube is not pinched between the rim and the edge of the
tyre. Lightly push the air valve inwards and pull it out again to make sure that the tyre is positioned
properly in the region of the air valve.
