Vermeiren Carpo 4 deluxe, Instruction Manual

Page: 23 / 40

Carpo 4 Deluxe
2012-04
Page 21
3.6 Adjusting the armrests
The angle of the armrest can be adjusted according following
instructions:
•
Rotate the knob at the back of the armrest up or down.
•
Adjust the armrest to a comfortable position.
•
Release the knob .
3.7 Tyre changing
L
L L
L
CAUTION: There must be no air in the tube before it can be removed.
L L L L
CAUTION: Risk of damage - If handled improperly, the rim might be damaged.
If you want to change the tyres or inner tubes, you should note the following:
Before you can remove a tyre, you must let all the air out of the tube, and insert a tyre lever between
the tyre and the rim. Then slowly and carefully push the lever downwards. This will pull the tyre over
the edge of the rim. If you then move the lever along the rim, the tyre will jump out. Now carefully
remove the tyre from the rim and then remove the tube.
Note the following before inserting the new tube:
Check the rim bed and the inside wall of the tyre for foreign matter and clean these properly if
necessary. Check the condition of the rim bed, especially around the position of the air valve. Please
use only genuine original replacement parts. No liability is accepted for damage caused by non-
genuine replacement parts. Kindly contact your specialist dealer.
Assembly:
L L L L
WARNING: Risk of injury - Check that the pressure is correct.
L L L L
CAUTION: Risk of injury - Make sure that no objects or body parts are pinched between the
tyre and the rim when mounting a tyre.
Put the deflated tube around the center of the rim.
Make sure that the valve juts out the valve opening in
the rim.
Push the tyre over the edge of the rim, starting behind
the air valve. Inflate the tube slightly until it is round,
and place it inside the tyre.
If the tube fits snugly inside the tyre without any folds
(in the case of folds: let out some air), then the upper
side of the tyre can be pressed lightly onto the rim
with both hands, starting at the air valve.
1