NeuroTrac
®
MultiTENS Operation Manual
10
Setting Programme Time for pre-set programmes
1.
Select P01 ~ P17 using the PRG 1 button.
2.
Press the SET button and the Clock symbol will flash ON/OFF,
then press the or – button to adjust the time between:
TENS Programmes 1-13: 30 minutes, 1 hour, 4 hours, 9 hours,
CON (continuous).
NMS Programmes 14-17: 30 minutes, 1 hour, 2hours.
3.
Press ESC to save the time for the selected programme.
Setting Custom Programmes
1.
Select PC1, 2 or 3 by pressing the PRG 1 button on the front panel.
Remove the battery lid where you will see two buttons SET and
ESC.
2.
Press the SET button once to customise a single phase.
Hold the SET button for three seconds to enter advance mode and
customise up to 5 phases. Press the SET button once to select the
next
phase.
3.
Press B + / - to set the phase time.
Press A + to select the phase mode.
4.
Press B + / - to select the phase mode: continuous (
CON
),
modulated (
MOD
), burst (
BST
), Neuromuscular stimulation
(
NMS
).
Press A+ to configure the phases parameters.
CON (continuous TENS mode)
1.
Press B + / - to set the frequency (
Hz
) between 2Hz and 200Hz
Press A + to set the Pulse Width.
2.
Press B + / - to set the pulse width (
µ
S
) between 50
µ
S and 450
µ
S.
NOTE: If frequency 105 Hz or higher is set, the pulse width will
be restricted to 300
µ
S maximum for safety.
3.
Press the SET button to configure the next phase or press the ESC
button to save the parameters.
