PREPARATION
1.Installing batteries/Connecting the AC adaptor
Batter compartment cover Batteries
Battery compartment
2. Setting up the scale/balance
△
!
CAUTION
Avoid installing the scale/balance in direct sunlight, it may cause discoloration or malfunctions.
Place your scale/balance on a firm weighing table so that the scale/balance is level. (The
scale/balance will not perform accurately when it is not level.)
Place the scale/balance on the firm surface that is flat and level for an accurate weighing.
Counting procedures
1.
Press [ON/OFF] to turn on the scale.
Wait for "0" to appear on the display.
2.
Start the Count Procedure
If necessary, press
[ZERO]
key to set the display to “0”.
3.
Place a given number of samples of an item on the pan (the sample size should be
either 10
、
20
、
50 or 100 pieces). The weight of these samples will show on the
display. Press the
[PCS]
key to put the scale in PCS mode, the display will show
X X pcs, press
[UNIT]
to select XX value (10 20 50 100).
4.
Press the
[PCS]
key, the display will show “XX pcs”, then the scale will recall
the sample size you selected and show the starting sample size on the display
(you can now remove the samples if you want to return the scale to 0)
5.
Press the
[UNIT]
key to return to the weighing mode
3
WEIGHING
Before weighing
Whenever possible, please allow the balance to warm up for 10 minutes after first
turning to power on, so that the balance will function properly and accurately.
Calibration may be required before weighing.
Read "CALIBRATION" first and if necessary, calibrate your scale/balance for
accurate weighing.
Weighing procedures
1.
Press [ON/OFF] to turn on the balance.
When power is turned on, all display segments appear on LCD for a few seconds
and finally "0" will appear on the display.
2.
Select the weighing unit with [UNIT].
Press
[UNIT]
to select a weighing unit, eg. "g"
、
" ct “
……
Once the unit has been selected, the selected unit will be displayed to the weight
value.
3.
Start weighing
If you do not use a container for weighing
Verify the reading is "0". If not, press
[ZERO]
to display "0".
Place objects on the weighing platform to weigh.
When the reading becomes stable, the stable indicator is displayed.
If you use a container for weighing
Place an empty container on the platform.
Wait for the stability indicator to be displayed and press
[ZERO]
.
Place the objects to be weighed in the container.
When the reading becomes stable, the stable indicator is displayed.
FEATURES
Auto calibration
●
Auto shut off (selectable)
Auto zero tracking
●
Auto backlight (selectable)
Low battery indication
●
g/ct….. conversion(selectable)
Lager LCD Display
●
with counting function(selectable)
USB
●
Net weight/stability indication
1/120000&1/200000 division available
Hogentogler & Co., Inc. / (800) 638-8582
9515 Gerwig Ln, Ste 109, Columbia, MD 21046
www.hogentogler.com
4
